FOX 7PC STEEL REAR SHOCK MOUNTING HARDWARE

The 7-piece Crush Washer eyelet hardware assembly is made up of two polymer (beige coloured) flanged bushings that are pressed into the shock eyelet. A hollow pin is pushed through the flanged bushings and centered by black Delrin spacers and Crush Washers on either side of the eyelet. Thin o-rings go between the spacers and flanged bushings to prevent contamination and premature bushing wear. The Crush Washers have raised domed portions that are depressed before installation and take up any play found between frame and hardware

• Please Note: This bushing reducer/hardware kit is enough for one eyelet of your rear shock; if replacing the bushings and hardware on both eyelets you need to purchase a quantity of 2 kits. Also note that many bikes use different sized hardware for each eyelet, so please verify which size you need before ordering.